精品国产乱码久久久久久1区2区,国产一国产一级毛片视频国,观看亚洲中文无码,国产精品ⅴ 一区二区三区,欧美三级网站高清国产不卡

The reason of the implementation and low efficiency of the machine bed sheet segment for CNC lathe manufacturers
One should be performed in one piece. CNC deep-hole drilling machine has a single-stage SBL execution function. After starting this function, the MCU will automatically terminate the processing operation each time it completes a control program. The CNC lathe operator must manually start the next program to start the machining operation. The advantage of single-segment execution is to give operators sufficient inspection time, including tool inspections, coordinate inspections, and program checks, to greatly avoid collisions. Although the single-stage execution reduces the efficiency of CNC lathe machining, it can greatly improve the machining quality and avoid collision problems. In contrast, the overall machining effect is better.
The second is a low magnification. By adjusting the speed adjustment knob of the CNC lathe to reduce the feed rate of the tool, you can observe whether the tool tip position and the coordinate display value are consistent before the tool performs workpiece processing. If the values ​​are not equal, the device can be shut down in time to avoid Collision problem. Especially when machining the inner hole of the workpiece, it is easy to cause the feed or retract error, which not only affects the machining quality of the inner hole, but also results in serious deviation of the size of the inner hole of the workpiece, as well as the problem of knives and collisions. Therefore, the use of low magnification processing speed can effectively avoid the above processing problems.
Accurately, it should be paused several times during automatic processing. Through the pause, the operator can have enough thoughts to prepare for observing and comparing the position of the tool tip and the display of the screen coordinates. In particular, when the chip is wound on the workpiece or the tool, it can press the cycle stop button to use this time to solve the CNC lathe. The problems occurred in the processing to prevent errors in the operation due to panic.